FABModules Wiki
FAB Modules Pinout Assignments

All FABModules connect to each other via standard 0.1″ pitch Male/Female headers.

INPUTS will be Female 2×5, 0.1″ pitch headers. (Note: In diagrams below, INPUTS are shown with a notch. But in reality, they are Female Headers and do not have a notch.}

OUTPUTS will be Male 2×5, 0.1″ pitch headers.

The 2×5 Header pin outs are as follows. Note the location of the “notch”. The headers will be inserted/soldered on the edge of the PCB with all ODD-Numbered Pins on the top copper side, and all EVEN-Numbered Pins on the bottom copper side. See diagram below.

This is the TOP-SIDE VIEW. Note the RED Color of the PCB, as represented by Eagle CAD.

INPUT JACK, TOP SIDE PIN OUT:

  • (3) IN-
  • (5) GND
  • (7) IN+

OUTPUT JACK, TOP SIDE PIN OUT:

  • (3) OUT+
  • (5) GND
  • (7) OUT-

This is the BOTTOM-SIDE VIEW. Note the BLUE Color of the PCB, as represented by Eagle CAD.

INPUT JACK, BOTTOM SIDE PIN OUT:

  • (2) +48V
  • (4) V+
  • (6) GND
  • (8) V-

OUTPUT JACK, BOTTOM SIDE PIN OUT:

  • (4) V-
  • (6) GND
  • (8) V+
  • (10) +48V